First, its lifting of security procedures:
1, if the vehicle is to be treated by the trip computer owners use to set their own security code BMW car and did not know the password control security release, the following methods can be forcibly disarm program:
⑴, remove BMW battery cable, and then re-install.
⑵, open the driver's side door, the ignition switch diverted ON (R or 15 positions).
⑶, after waiting for 15min, to automatically lift the security password
◆ If for trip computer failure caused by anti-theft lock can not be released, what methods can be lifted:
Method 1: 55 foot digital engine control computer (DME) 38 # anti-theft wire removed, can be lifted.
Method 2: 88 foot digital engine control computer (DME) 81 # anti-theft wire removed, can be lifted.
Method 3: BMW 7 Series lin.e 6-cylinder, 8-cylinder models of the 88 foot digital engine control computer (DME) 66 # anti-theft wire removed, can be lifted.
2, if the BMW factory configuration of the
car remote control of the vehicle, you can simply press the remote control to open the door UNLOCK button, or use the key to open the door from the driver's side, it can automatically lift the security.
3, BMW cars are three configuration push-button remote control, lifting its security procedures:
⑴, pulled, do not press the central locking.
⑵, twist the ignition switch to the ON position, and then back to the OFF position within 5S.
⑶, press the down arrow key on the key, while pressing the LOCK button three times in the 10s
BMW car key match
Second, anti-theft remote control BMW models resetting procedures:
1, if the car uses a single bond and 3-button remote control, and because the battery is dead and other reasons caused by the failure of the remote control, it must be reprogrammed as follows:
⑴, open the remote control cover with a small Phillips screwdriver.
⑵, taken behind a small wafer.
⑶, to find the remote control receiver computer (usually located under the dashboard, or the left and right lower side of the seat).
⑷, open the small lid on the remote control receiver to a computer and removed in step ⑵ wafer into them.
⑸, if the RESET button on the receiver computer, press that key. If there is no RESET key, you need to turn the ignition switch to the ON position (R or 15), then transferred back to the OFF position to complete the reset.
2, BMW cars if a three-button remote control type D, then the reset procedure is:
⑴, the ignition switch is turned on.
⑵, the remote control closer to the receiver, the closer the better.
⑶, press the remote control and UNLOCK button until the LED light starts blinking, it means the program set up.
⑷, after the program has been started 15S time, we can continue to re-set the other remote control, but can only be set up to four remote control.
3, BMW cars, if used with the key to one of the remote control (respectively double and 3 push-button), which set the program are:
Two-button remote control (buttons, respectively UNLOCK key and DOUBLELOCK key):
⑴, all doors are closed, do not press the central locking.
⑵, twist the ignition switch to the ON position, in the 5S back to the OFF position.
⑶, press the UNLOCK / LOCK key within 10S press DOUBLELOCK key three times.
⑷, release the UNLOCK / LOCK key and the key LED light flashes 10 times.
⑸, the key remote close to the receiver (rearview mirror), press the UNLOCK / LOCK button or DOUBLELOCK key once.
⑹, this time the car door will automatically lock and then turn it on again, indicating the completion of reset.
⑺, repeat steps ⑶ ~ ⑹, you can then set the other remote control, but must be completed within 15min, while once again set up to three remote control.
